PE T-Joint 25 mm

PE T-Joint 25 mm – tee for the main line of larger irrigation systems

In a larger grow room the 25 mm pipe is the backbone: it carries water from the pump to the different zones before thinner lines take over. This 25 mm PE tee is where that main line splits, so one pump can serve several tables, zones or drip circuits at the same time.

In practice

A typical layout: 25 mm from the pump along the wall, a tee at each table, and from there a reduction to 16 or 20 mm for the drippers. Because the main line is wide, there is plenty of flow left for both branches, and the plants at the far end of the room still get their share.

Good to know

Thick pipe is stiffer, so cutting and seating take a bit more care. Use a proper pipe cutter rather than a knife for a clean, square end. Push or tighten each of the three ends fully into the tee. Pressure-test the whole system with plain water before the first feed and walk the line looking for drips, especially around the joints close to the pump where pressure is highest.

Specifications

• Pipe size: 25 mm PE
• Shape: T-joint (tee)
• Material: PE / plastic

For a complete main line, combine with 25 mm elbows, end pieces and the 25 mm x 1" threaded adapter to link up with your pump or filter.